![]() Unless someone can suggest a better program (my first designs, 30+ years ago, were done using a DOS version of Calsod). Then of course I'll have to learn Xsim from scratch. So I'm going to use REW, which I'm very familiar with, and have a calibrated testing mic, but haven't used it yet for impedance testing (another thing to learn). The next step will be getting the correct frd and zma files (hence this posted topic).Īs this is a one-off project, I don't want to buy DATs. The Vifa is in its own sealed enclosure at the top of the box. Using Hornresp over several weeks, I believe I have a good TL design and have started to build the enclosure. This program will allow you to save the traced data to a. If you are using a picture like you would find in a manufacturer data sheet or at a site like Zaphs you can trace this data with the program at the link below. There are many advantages to using a sine wave sweep versus pink or white noise. FuzzMeasure is an audio and acoustic measurement tool to produce, analyze, and publish beautiful graphs. As with most room measuring software, REW uses a sine wave sweep as its signal source. You need measured frequency and impedance response of the driver. In the next part Nyal Mellor will offer similar information about FuzzMeasure, a popular and highly capable program for Mac computers. Goto control tab, you should see your response here now with the diffraction included. Goto diffraction tab and mess with the diffraction thingy, then press 'use diffraction model' 3. Goto low frequency tab and load traced FRD 2. So I've probably haven't approached the design like an experienced enthusiast would. You need a few things for this to happen. One spreadsheet process using FRD Blender, step-by-step 1. So instead of researching suitable drivers (for enclosure and pairing), I jumped straight in and bought the drivers. I also liked what I read about the Dayton RS225-8 in a transmission line, and that it teamed well with the Vifa TC9FD-08. The pick line should then align.I've got the diy bug again after a 20 year layoff.ĭoing some casual online reading, I became interested in transmission line and some of the current free software that was available. A pink line will show up, if it is not perfectly align just adjust the part that is misaligned, but clicking on the graph (the place where the line should be). ![]() Once set, click on what you want to trace. All you need to do is set the limits on the left hand side. It was not very efficient or user friendly. Well that was not only a pain, but could take over 10 minutes to get a good trace. You also had to pay close attention to see if it was tracing it correctly. In the past, i used SPL copy, which worked, but you had to manually trace the line if the program could not find it. Or at least, not until now.įPGraphTracer has become one of my favorite free programs. By accurately measuring the frequency response of a room or electrical component. ![]() In fact some companies only give you the information you need in a PDF file with no easy way to extract the data. FuzzMeasure allows you to see and understand the acoustic properties of audio equipment and listening spaces. Now there are many ways to go about attaining those files, but it is not always easy to find them. In order to make a custom crossover you need to have the FRD and ZMA files.
0 Comments
Leave a Reply. |